Tech Session - Updated - New Date, 8/7/11

[MikeH]

Anybody coming that has the tools to do a volume (CC) check on my heads? Haven't seen how that is done and would be interesting to check them before they go back on.

[BeetleBob]

I'll be there to lend a hand and look over your shoulder.

[ghiastein]

Good my rear wheel bearings arrived.

Now I have to clean the old grease from everything.

See everyone Sunday

[67type1]

Mike, sorry, but I don't have the tools to cc the heads.

Look forward to seeing everyone. I'll have things to drink (water & pop) and some snacks and sloppy joes for later on.

[Ruffuss]

Sorry Ray, I was told I have plans??? If I do make it, it will be late in the afternoon.

[MikeH]

I don't expect to be there until 2pm. Everything is loaded in the truck. Have to get to church, grab some lunch and will be there around 2.

[67type1]

Thanks to those who could make it (AJ, Mike, Bob, Paul, Steve & Aki). I always enjoy meeting everyone and learning something new.

Mike brought his FI engine to put the top end back together and take the long block home. Aki brought his mystery pieces - we think its one of the valve seals. Big thanks to AJ, he brought an engine stand various tools and his expertise. AJ also put his rear axle bearing assemblies together.

Here's a few photos...


Aki's mystery pieces


Mike torqueing the heads


AJ's rear hub assemblies


Mike's engine just before we took it off the stand to recheck endplay, install main seal, flywheel and clutch assembly

[MikeH]

Notice who's sitting and who's working

[MikeH]

Thanks for all the help and editorial comments. It was both entertaining and productive.

[BeetleBob]

THANK YOU, RAY
It was a wonderful experience meeting you and some of the members and seeing your amazing shop.
I haven't been to a Tech Session for at least 15 years, but this is the kind that I will be attending again. ;D
Everyone is so friendly and helpful it's the same thing I experienced at the South Haven show.
Great to be associated with such fine people.

Thanks again for a great time,
Bob

[67type1]

Bob, It was good meeting you. Your 74' Beetle is super clean! Thanks for coming out.

[teamafx]

Notice who's sitting and who's working

The reason I am sitting..... you said you wanted it to run when you were done..... without my help it should run ;D

[teamafx]

I had a great time as always. Thanks Ray! Maybe the next one I can get there on time. I hope everyone finished up with what they needed done.

[67type1]

Steve, don't short change yourself. You & many others in the club are an infinite resource of info & help. I'm glad to get to know everyone and learn something in the process.

[teeniebits]

I can say that I'm not shocked that Steve sat while the others worked -- welcome to my world, guys!

Ray - You're awesome to open up your shop like this, I know everyone greatly appreciates it!!